Compliance Checklist: Will You Be Ready if OSHA Visits Your Jobsite? - Remodeling Magazine

Below is short a list of things contractors should consider if they want to be ready when an OSHA Inspector drives by and or stops in to check out your job site.  This list comes from Mark Paskell of The Contractors Coaching Partnership.  Mark helps contractors and their employees comply with OSHA. He offers group training classes as well as company specific training and assistance with compliance requirements including jobsite practices and the gamut of required documentation.  When I spoke to Mark about this topic he stressed that OSHA was concentrating heavily on worker training and protection from fall hazards, and that contractors needed to have written documentation of the training they provide.

 

OSHA Compliance Checklist for Contractors:

• Keep your job site in a clean an orderly manner
• If on roofs above a 4 pitch use anchor points, harnesses and lifelines
• If you do not use harnesses use guard rails
• When setting ladders make sure they are 3 feet above the roof edge and on stable ground
• Don't use ladder jacks with ladders over 20 feet
• If you use ladder jacks over 10 feet makes sure you are tied off from above
• Wear hard hats and safety goggles
• Make sure scaffolding is set properly with planking
• Set ladders at the right angle
• Don't climb scaffolding bracing
• Don't use the top steps of your step ladders
• Use ladders and step ladders only within the manufacturer's parameters 
• Use guard rails on pump staging and do not forget the ends
• Cover skylights in the work area
• Always us guard rails on landings, stairs and ramps
• Use guard rails across large openings on upper levels
• Don't set ladders or staging within 10 feet of power lines

http://soc.li/oyRGDFh